Service manual

KB-3300JS

KB-3300JK

KB-3300JW

BLOWER MOTOR REMOVAL

1. Disconnect the power supply cord.

2. Refer to the disassembly instructions found on Pages 38 - 40.

3. Unhook all wiring from Blower Motor (Fig. O-11)

4. Remove tape from Thermistor rear hole.

5. Remove the (2) screws holding the Blower Motor to the Rear Plate.

6. The Blower Motor is now free.

7. Proceed in reverse to reinstall the Blower Motor.

Fig. O-11

LOCK MOTOR REMOVAL

1. Disconnect the power supply cord.

2. Refer to the disassembly instructions found on Pages 38 - 40.

3. Unhook all wiring from Lock Motor (Fig. O-12).

4. Remove the (2) screws holding the Lock Motor to the Rear Plate.

5. Pull Lock Motor from Lock Motor Shaft.

6. The Lock Motor is now free.

7. Proceed in reverse to reinstall the Thermistor.

Fig. O-12