User`s manual

6-16
[2] Connector type of 32/64 points
(1) Assembly of the connector
Assemble the connector following the procedures below.
Note that the terminal numbers of the connector are not identical with address numbers.
1) Insert insulation tube into signal line.
2) Solder signal line to connector terminal.
Confirm the connector terminal and its address number, before soldering.
3) Assemble connector.
Assembly parts (screws, washers and nuts) are attached to the connector.
Use the following recommended cable for the signal line.
Recommended cable: Multiple vinyl insulation vinyl sheath cable
18P x 0.18 57VV-SB (made by FUJIKURA LTD.)
(2) Connection with the module
Ensure correct connection for polarity of the input power supply. Mis-connection of the polarity will
destroy the module when the power is supplied.
Attached connector of 32/64 points I/O module is soldering type, and available for connector of
pressure welding/crimp-style.
Insert a tube
Soldering
Jack
Washer
Cover
2N
2N
2N
2M x 10
2M x 10
2M x 8
2M x 8
Use a slot screwdriver