User`s manual

5-9

5-6 Installation of I/O bus expansion adapter (JW-31EA/32EA)

Install JW-31EA on an I/O expansion connector on the right edge of the basic rack panel, JW-314KB,

etc.

Install JW-32EA on an I/O expansion connector on the right edge of the expansion rack panel, JW-

34ZB, etc.

[Installation procedure]

1) Insert a termination connector, which is an accessory of the JW-31EA, into the JW-32EA only on

the last expansion rack panel.

2) Install a JW-31EA in an I/O expansion connector on the basic rack panel, in the same way as a JW-

32EA in an I/O expansion connector on the expansion rack panel.

3) Tighten module-fixing screws on the upper and lower sides of the JW-31EA/32EA.

Fasten the screw with a torque of less than 1.47 N-cm.

JW-31EA

Termination connector

JW-32EA JW-32EA

JW-32EA

Termination connector

installation port

Termination connector

(comes with JW-31EA)

JW-32EA

Expansion rack panel

(JW-34ZB, etc.)

I/O expansion connector (IN)

Basic rack panel

(JW-314KB, etc.)

I/O expansion connector (OUT)

JW-31EA JW-32EA

Phillips screwdriver

JW-32EAJW-31EA