User`s manual

5-8
[2] Installation of module cover
Module cover JW-20CV is a cover fitted on a terminal block of the I/O / special I/O / option / I/O link
module to which external cables are connected.
Module covers are ordered separately (8 sets in one pack.)
[Installation procedure]
1) Put the external lines connected to the I/O / special I/O / option / I/O link module into the
portion reserved for storage portion.
- When the external lines can not be stored in the storage portion, repeat connecting the
external lines to the terminal block.
- Put the terminal cover on after installing the external lines in the storage portion.
2) Hang the screw at the lower part of the module cover on terminal block, and insert the upper
part of the module cover between the LED display panel and the terminal block of the module.
[3] Installation of input/output module sideboard
When power supply module is not installed in the expansion rack panel, attach the sideboard for
I/O module supplied with the expansion rack panel (called sideboard hereinafter) to the left end
module. The side plate prevents dust from entering into the module.
When the power supply module is installed on the expansion rack panel, do not install the side
board. Otherwise, module cannot be installed properly.
[Installation procedure]
Hang sideboard craw on the side of module in order to fix sideboard, and push sideboard
toward module.
Module cover
External lines
Storage portion
Terminal cover
Sideboard