User`s manual

5-6
5-4 Installation of control module
Install the control module (JW-3**CU) at the basic rack panel (the power supply module on the right.)
[Installation procedure]
1) First, catch the module securing rib in a securing rib hole on the basic rack panel. Then, push the
module in toward the basic rack panel.
2) Tighten one module retention screw of the control module using a Phillips screwdriver. Fasten the
screw with a torque of less than 1.47 N-m.
× ○
Partition plate or
control panel
Basic rack panel
Module inserting guide
Module retention rib
Inserting hole of module retention rib
Module retention screw
Power supply module
Phillips screwdriver
Basic rack panel
Control module