User`s manual

5-3

To the next page

[2]

Installation of basic/expansion rack panel in control panel

1) Drill fitting holes of basic/expansion rack panel and wiring duct on the control panel and

partition plate.

- Refer to previous page for fitting dimension of the basic/expansion rack panel.

- Keep each rack panel at 50 to 150 mm distance and more, from right and left sides of each

rack panel to the end of the panel and the wiring duct for 50 mm and more.

- Keep wiring duct 30 mm distance or more from the basic/expansion rack panel for vertical

directions.

2) Fix basic/expansion rack panel on partition plate using M5 screws.

- Prepare M5 retention screws locally. (Recommended installation screw: M5 x 12 mm)

▲

Wiring duct

Class-D grounding

Halt output

AC/DC

power supply

5 VDC cable

110mm

30mm

Wiring

duct

30mm

50 to

150mm

I/O expansion

cable

50 mm or more

Partition panel

M5 screw hole

M5 screw

Basic/expansion rack panel