User`s manual

4-1
4-1 Control module (JW-3**CU)
Chapter 4. Name and function of each part
Software
version
label
Model name label
Module retention screw
Rating plate
(1pc.)
(13)
(12)
(11)
(1)
(2)
(3)
(4)
(5)
(6)
(15)
(16)
(17)
(9)
(14)
(10)
(7)
(8)
PG/COMM1
PG/COMM2
▲
PULL
電池交換
時期
This
battery
expires
電池の交換
は５分以内
に行ってく
ださい
Exchange
the battery
within
５minutes.
ＲＵＮ
ＦＬＴ
ＣＭ１
ＣＭ２
ＵＳＢ
Ｃ
Ａ
Ｒ
Ｄ
←
Ｆ
Ｆ
Ｏ
MW
ＰＲＯＴＥＣＴ
AUTO LD
ＲＥＳＥＴ
(7)
(8)
(9)
(1)
(2)
(3)
(4)
(5)
(6)
Name Function
CM2 lamp (yellow)
MW lamp (red)
USB lamp (yelow)
RUN lamp (green)
CARD lamp
PROTECT switch
AUTO LD switch
CM1 lamp (yellow)
FAULT lamp (red)
Lights when detecting errors by self-diagnosis.
JW300 stops its operations. (However, it operates even when battery
is error.)
Lights when communicating with personal computer or the like, by
using PG/COMM2 port. Lights up in monitoring state by connecting a
support tool.
Lights when the JW300 is communicating through its USB port.
Blinks when changing the program memory.
Goes OFF when special relay 7331 is turned ON.
Lights when communicating with personal computer or the like, by
using PG/COMM1 port. Lights up in monitoring state by connecting a
support tool.
Set prohibit (ON), enable (OFF) about writing to program memory
and system memory.
Select a mode for the memory card
- When it is slid to the ON position, the JW300 automatically loads
programs and data from a memory card (compact flash card)
immediately after the power is turned ON.
Lights, blinks, and goes OFF, according to JW300 operating condition.
- Lights when the JW300 is operating.
- Blinks when the JW300 is being programmed by a connected support
tool (the JW300 stops calculating.)
- Goes OFF when the JW300 detects an error using its self-diagnosis
function. (Lights when a battery error occurs.)
Lights when the JW300 is accessing a PC card.
Next page