User`s manual

7-6
(1) Auto registration
The control modules automatically register I/O addresses, using sequential addresses starting from
" 00000," in the same order as the rack numbers (0 to 7).
- Number of I/O points and I/O relay area.
Shown below are examples using basic rack panel (JW-318KB) and 7 expansion rack panels (JW-
38ZB.)
- No. of I/O points, No. of all allocation points of I/O relays => See page 7-10.
Note: The I/O mounted on the remote I/O slave station JW-21RS is not registered automatically.
When the master station is JW-21CM and the slave station is JW-21RS, the I/O registration
of slave station is registered in the parameter of JW-21CM.
eludomlortnoC stniopO/Ifo.oN
stniopnoitacollafo.oN
syalerO/Ifo
aerayalerO/I
UC213/UC113-WJstnipo215stniop0821.xaM.xaM
.xaM
73200ot00000
UC223/UC123-WJ
stniop4201
.xaM
stniop
stniop6351.xaM77200ot00000
UC233/UC133-WJ
6904stniop8402.xaM77300ot00000
UC243/UC143-WJ
UC253-WJ
UC263-WJ
ｺ
ｺ
ｺｺ
ｺ
ｺ
Rack No. 3
Rack No. 2
Rack No. 1
ｺ0000
Rack No. 0
Rack No. 7
Rack No. 6
Rack No. 5
Rack No. 4
- In the example above, the rack numbers are listed in order installed.
ｺ