Instruction manual

6 - 6
Ex. 2 Measurement 1 Workpiece dimension measurement (Number of registration 1)
• Maximum number of detection 3 = output as much as 2 labels, output data = total area,
Number of workpiece, area for each workpiece, barycenter, and midpoint
Total area Number of
workpiece
(Registration 0)
( Registration 0 )
Area for each workpiece Center of
gravity X
Center of
gravity Y
Midpoint X Midpoint Y
Registration 0 Registration 0 Registration 0 Registration 0 Registration 0
Label 0 Label 0 Label 0 Label 0 Label 0
Area for each workpiece Midpoint X Midpoint Y
Registration 0 Registration 0 Registration 0 Registration 0 Registration 0
Label 1 Label 1 Label 1 Label 1 Label 1
Center of
gravity X
Center of
gravity Y
Area for each workpiece Midpoint X Midpoint Y
Registration 0 Registration 0 Registration 0 Registration 0 Registration 0
Label 2 Label 2 Label 2 Label 2 Label 2
Center of
gravity X
Center of
gravity Y
[Example of HMI]
[Output data (general purpose serial)]
Packet 0 Measurement 1 Registration 0 Total area 4 bytes
Number of workpiece 2 bytes
Label 0
Area for each workpiece 2 bytes
Label 0 Center of gravity X 2 bytes
Center of gravity Y 2 bytes
Label 0 Midpoint X 2 bytes
Midpoint Y 2 bytes
Label 1 Area for each workpiece 4 bytes
Label 1 Center of gravity X 2 bytes
Center of gravity Y 2 bytes
Label 1 Midpoint X 2 bytes
Midpoint Y 2 bytes
Label 2 Area for each workpiece 4 bytes
Label 2 Center of gravity X 2 bytes
Center of gravity Y 2 bytes
Label 2 Midpoint X 2 bytes
Midpoint Y 2 bytes
F C1 BRT