User`s manual
Table Of Contents
- Safety Precautions
- Table of contents
- Chapter 1: Outline
- 1-1 Features
- 1-2 Controller
- 1-3 Measurement program
- [1] Positional deviation measurement
- [2] Degree of match inspection
- [3] Lead inspection
- [4] BGA/CSP inspection (IV-S32M/S33M)
- [5] Area measurement by binary conversion
- [6] Object counting by binary conversion
- [7] Object identification by binary conversion
- [8] Point measurements
- [9] Distance and angle measurement
- [10] Multiple position measurement (IV-S33M)
- [11] Multiple degree of match inspection (IV-S33M)
- Chapter 2 : Precautions for Use
- Chapter 3 : System Configuration
- Chapter 4 : Part Names and Functions
- Chapter 5 : Connection and Installation Methods
- Chapter 6 : Setting and Operating Outlines
- Chapter 7 : Simplified Menu Operation
- 7-1 Operation screen
- 7-2 Image display
- 7-3 Setting functions that are different with each controller
- 7-4 Setting procedures
- 7-5 Setting the operation conditions
- 7-6 Setting object types
- 7-7 Setting the shutter speed
- 7-8 Setting the positioning conditions
- 7-9 Setting the existence inspection conditions
- 7-10 Measurement triggering
- 7-11 Saving data
- 7-12 Specify the system conditions
- Chapter 8 : Specifications
- Chapter 9 : Operation Examples
- Glossary
- Appendix
- Alphabetical Index
5-12
5
Connection and Installation Methods
3 Connect the monitor to the monitor connector (VIDEO: RCA jack) on the controller using the
monitor cable (supplied with the controller) and a conversion connector (supplied with controller).
If the monitor has an RCA jack, the conversion connector is not required.
- Use a monitor with either an EIA or NTSC compatible video input terminal.
- Connect the cable to the monitor connector straight and treat it carefully.
- If you need a monitor cable longer than 2 m, you can purchase a one at a video store.
4 For details about connecting and installing cameras, see page 5-23 in this manual.
Monitor
Monitor
Monitor connector (VIDEO)
Controller
BNC connector
Conversion
connector
Monitor cable
(Cable length 2 m)
RCA jack
Ë Ë
Ë Ë
Ë Leave enough space around the controller (IV-S31M/S32M/S33M)
In order to connect camera cables, the remote key pad cable, monitor cable and D-sub connector to
the controller, the following space (min.) is required.
IV-S3＊M
OUTPUT
INPUT
POWER
Y7Y0 Y1 Y2 Y3 Y4 Y5 Y6
COM
COM
＋24V
X7X0 X1 X2 X3 X4 X5 X6
READY
0V
VIDEO
CAMERA1
CAMERA2
USB
RS232C/RS422
REMOTE
Camera cable
9mm9mm
130mm
148mm
92mm100mm
(minimum)
· Do not bend the camera cables repeatedly.
· Make sure the installation location allows
enough space for the input/output wires going to
the I/O terminal block and the power terminal
block on the controller.