User`s manual
Table Of Contents
- Safety Precautions
- Table of contents
- Chapter 1: Outline
- 1-1 Features
- 1-2 Controller
- 1-3 Measurement program
- [1] Positional deviation measurement
- [2] Degree of match inspection
- [3] Lead inspection
- [4] BGA/CSP inspection (IV-S32M/S33M)
- [5] Area measurement by binary conversion
- [6] Object counting by binary conversion
- [7] Object identification by binary conversion
- [8] Point measurements
- [9] Distance and angle measurement
- [10] Multiple position measurement (IV-S33M)
- [11] Multiple degree of match inspection (IV-S33M)
- Chapter 2 : Precautions for Use
- Chapter 3 : System Configuration
- Chapter 4 : Part Names and Functions
- Chapter 5 : Connection and Installation Methods
- Chapter 6 : Setting and Operating Outlines
- Chapter 7 : Simplified Menu Operation
- 7-1 Operation screen
- 7-2 Image display
- 7-3 Setting functions that are different with each controller
- 7-4 Setting procedures
- 7-5 Setting the operation conditions
- 7-6 Setting object types
- 7-7 Setting the shutter speed
- 7-8 Setting the positioning conditions
- 7-9 Setting the existence inspection conditions
- 7-10 Measurement triggering
- 7-11 Saving data
- 7-12 Specify the system conditions
- Chapter 8 : Specifications
- Chapter 9 : Operation Examples
- Glossary
- Appendix
- Alphabetical Index
9-9
9
Operation Examples (Simplified menu: Existence inspection)
*2
F.IMG C1 L
VX.XX
(TYPE00)
OK
MEAS XXXXms 2000-08-01 10:30
MEASUREMENT1 EXISTENCE
CHG-TYPE EXIST-COND EXIST-EVAL. SEL-CAMERA
OPS-CND SYS-CND ADJ-CONTRAST SAVE SHUTTER
X0~7 Y0~7 READY
Continued from the previous page
Press the TRG/BRT key, and the result of measuring (evaluating) and image (search) area will be displayed.
(9) Existence inspection
*1 The final evaluation result will be displayed as "OK" in the upper left corner of the screen when all of the
items have been evaluated as acceptable. If there is a single unacceptable item, "NG" will be displayed.
The only item evaluated in the existence inspection is the area. The result will be OK if it falls within the
evaluation conditions that are specified in step (8) (upper and lower limits).
*2 Although the specified data is temporarily stored in RAM memory, it is not stored in the flash memory.
So, you must save the data manually using the save operation. If you do not save the data in the flash
memory, it will be deleted when the IV-S30 controller is turned OFF. - See page 7-26.
[Display of the measured
result]
Final evaluation result (*1)
Measuring time
Area of registration number 00
(number of pixels) and
evaluation result