User`s manual

5-9
5
Connection and Installation Methods
Leave enough space around the controller (IV-C35M)
In order to connect camera cables, the remote key pad cable, monitor cable and D-sub connector to
the controller, the following space (min.) is required.
· Do not bend the camera cables repeat-
edly.
· Make sure the installation location allows
enough space for the input/output wires
going to the I/O terminal block and the
power terminal block on the controller.
* Monitor cable and D-sub connector are
accessories of the IV-C35M controller.
[2] Installation
To install the IV-C35M controller, secure the bottom of the housing on the mounting surface with the two
main housing brackets (supplied with the controller.)
Mounting procedure
1. Install the main housing angle bracket at the bottom of the IV-C35M housing, and secure using 4
screws (M3 x 6: Accessory).
Camera cable
Monitor cable*
100mm
(minimum)
D-sub connector*
Card cover
IV-C35M
OUTPUT
INPUT
POWER
Y7Y0 Y1 Y2 Y3 Y4 Y5 Y6
COM
COM
＋24V
X7X0 X1 X2 X3 X4 X5 X6
READY
0V
VIDEO
CAMERA1
CAMERA2
USBCOMPACTFLASH
RS232C/RS422
REMOTE
9mm9mm
130mm
148mm
100mm
Mounting surface
Main housing bracket
Main housing bracket
(2 pcs.)
Screw installation position
(4 places)
Bottom view
- When using a memory card, install a card
cover (accessory) on the IV-C35M housing.
See page 6-17.