User`s manual

4-2
Part Names and Functions
4
4-2 Camera
[1] Camera
(1) Color camera (IV-C30C5)
-To connect a color camera (IV-C30C5) to the IV-C35M controller, use the camera cable (IV-
S30KC3/KC5) shown above.
(2) High-speed monochrome camera (IV-S30C3)
- To connect a high-speed monochrome camera (IV-S30C3) to the IV-C35M controller, use camera
cable (IV-S30KC3/KC5) shown above.
Lens holder
FunctionName
The holder is used to make fine adjustment to the distance (back plane fo-
cus) between the CCD section and camera lens using a focus fixed lens.
(The distance has been adjusted before shipment. Usually, it does not
need to be adjusted.)
- To adjust it, loosen the upper lock screw, and turn the lens holder coun-
ter-clockwise. The maximum allowable distance is 1.5 mm.
Cable
connector
Connect this connector to the camera cable (IV-S30KC3/KC5).
2
1
2 Cable connector
CCD section
1 Lens holder
Front view (view A) of the CCD
Lock screw (for securing the lens holder)
⇒
A
Lens holder
FunctionName
The holder is used to make fine adjustment to the distance (back plane fo-
cus) between the CCD section and camera lens using a focus fixed lens.
(The distance has been adjusted before shipment. Usually, it does not
need to be adjusted.)
- To adjust it, loosen the upper lock screw, and turn the lens holder coun-
ter-clockwise. The maximum allowable distance is 1.5 mm.
Cable
connector
Connect this connector to the camera cable (IV-S30KC3/KC5).
2
1
2 Cable connector
CCD section
1 Lens holder
Front view (view A) of the CCD
Lock screw (for securing the lens holder)
⇒
A