User`s manual

4-1
Part Names and Functions
4
Chapter 4: Part Names and Functions
This section describes the names and functions of the controller, camera (camera body, camera
converter, camera lens and camera cable), and the remote keypad which comprise the IV-C35M
system.
See section in Chapter 5 "Connection and Installation Methods" for details about the housing
brackets and camera angle bracket.
4-1 Controller (IV-C35M)
Frame ground terminal
9
Be sure to ground the housing frame ground terminal together with
the frame ground of the constant-voltage power supply in accor-
dance with class 3 grounding procedures.
I/O terminal block
INPUT: X0 to X7, C
(+)
OUTPUT: Y0 to Y7,
READY, COM
Name
This block has 8 input terminals and 9 output terminals.
- External devices are connected to these terminals for input and
output (parallel I/F).
1
Power terminal block
(＋24V, 0V)
2
Power lamp (POWER)
3
Monitor connector
(VIDEO)
4
Camera 1 connector
(CAMERA1)
5
Camera 2 connector
(CAMERA2)
6
Remote key pad connector
(REMOTE)
8
Commercially available constant-voltage power supply (24 V DC ±
10%, 700 mA or more) is connected here.
When the power is applied to the controller, the green lamp will light.
A monitor is connected here.
- The monitor connector is an RCA female connector .
The camera cable connector is connected here.
- The camera connected to the CAMERA 1 position is camera 1,
and the camera connected to the CAMERA 2 position is camera 2.
This connector is used to connect a personal computer for communi-
cations (general purpose serial I/F) or to connect a programmable
controller for a computer link.
The remote keypad connector is used to make selections from the
menus on the screen (to set parameters). It is connected here.
Function
7
0
q
Communication connector
(USB)
This connector is used to connect a cable to a USB port on a person-
al computer.
- The USB port only functions with Windows 98/Me.
Communication connector
(RS232C/RS422: 9-pin D-
sub female, rock screw M2.6)
Memory card connector
(COMPACTFLASH)
Connect a memory card (compact flash) that will be used to save
setting parameters, NG images, etc
S＊.＊＊
2 Power terminal block
4 Monitor connector (VIDEO)
qMemory card connector
(with connect cover)
8 Remote key pad connector
(REMOTE)
7 Communication connector
(RS232C/RS422)
IV-C35M (front)
IV-C35M (side)
1 I/O terminal block
3 Power lamp (POWER)
5 Camera 1 connector (CAMERA1)
6 Camera 2 connector (CAMERA2)
mark
(Software version ＊.＊＊)
IV-C35M
OUTPUT
INPUT
POWER
Y7Y0 Y1 Y2 Y3 Y4 Y5 Y6
COM
COM
＋24V
X7X0 X1 X2 X3 X4 X5 X6
READY
0V
VIDEO
CAMERA1
CAMERA2
COMPACTFLASH
USB
RS232C/RS422
REMOTE
0 Communication
connector (USB)
9 Frame ground
terminal