User`s manual

ManualsBrandsSharp ManualsDigital CameraIV-C35M

3-3

System Configuration

3-2 System configuration examples

This section outlines the system configurations for measurement using an external trigger, as follows:

- Measurement using a photo sensor.

- Measurement using CCD trigger.

- Measurement triggered by a command from a personal computer.

See "Chapter 21: Setting the Input/Output Conditions" in the IV-C35M User’s Manual (Function and

Operation).

[1] System configuration example for measurement triggered by an external

trigger, such as a photo sensor

(1) When IV-C35M is used in a stand-alone mode

- Purpose/application

Measurement is started by an external trigger (a photo sensor or proximity sensor), and the

measurement result is output externally (warning lamp). The object type number is selected by

an external switch.

(2) When a programmable controller is connected

- Purpose/application

Measurement is started by an external trigger (a photo sensor or proximity sensor), and the

measurement data is output to a programmable controller. The object type number is selected

by the programmable controller.

Power supply (24 VDC)

IV-S3＊M

OUTPUT

INPUT

POWER

Y7Y0 Y1 Y2 Y3 Y4 Y5 Y6

COM

＋24V

X7X0 X1 X2 X3 X4 X5 X6

READY

VIDEO

CAMERA1

CAMERA2

USB

RS232C/RS422

REMOTE

Monitor

Camera 1 (image)

Camera 2 (image)

Remote keypad

External trigger

(a photo sensor or proximity

sensor, etc.)

Object type selection switch

External

output

Warning lamp etc.

Controller