User`s manual

7-31
Setting Examples Using the Set Wizard
7
= In this example, the settings on the STEP8 (DST&AGL COND SET) to STEP8 (MAIN OPS
MENU) are not changed. Select "NEXT" on each of these screens to go to the next screen. =
1 ■
2 □
STEP8
STEP8 STEP8
CALCULATE SETTINGS FOR ALL
MEASUREMENT RESULTS(YES/NO)
CHANGE DISPLY CONTENTS OF
THE MAIN OPS MENU
USE SETTING DESTANCE
ANGLE CONDITIONS (YES/NO)
ADD MEASUREMENT CONDITIONS?
NO
YES
RETURN NEXT
RETURN NEXT
RETURN NEXT
RETURN NEXT
RETURN NEXT
RETURN NEXT
STEP8
1
NO ■
2
YES(MEAS) □
STEP8
1
NO ■
2
YES □
STEP8
1
NO ■
2
YES □
STEP8
1
NO ■
2
COMPUTER LINK □
3
SERIAL I/F □
1
NO ■
2
YES(MEAS) □
3
YES(DST&AGL) □
1
NO ■
2
YES(MEAS) □
3
YES(DST&AGL) □
STEP8
1
NO ■
2
YES □
Settings for distance and angle
conditions.
- For details, see Chapter 18 in
Function and Operation.
Settings for measurement results.
- For details, see Chapter 19 in
Function and Operation.
Settings for measurement conditions.
- For details, see Chapter 3 in
Function and Operation.
Settings for the calculations applied
to all measurements.
- For details, see Chapter 19 in
Function and Operation.
Settings of interface to output results.
- For details, see Chapter 22 and 23
in Function and Operation.
Settings for displaying the operation
screen.
- For details, see page 6-14.
Settings for the calculations applied
to all measurements.
- For details, see Chapter 19 in
Function and Operation.
Output settings.
- For details, see Chapter 22 in
Function and Operation.
LADDER CIRCUIT AND RESULT
OUTPUT BASED ON MEASUREMENT
AND CALCULATION RESULT (YES/NO)
COMPARE MEASUREMENT
SETTINGS TO MEASUREMENT
RESULTS (YES/NO)
SELECT AN INTERFACE FOR
OUTPUTTING RESULTS WHEN THE
INPUT IS THE PARALLEL I/F
SET LADDER CIRCUIT RESULT
OUTPUT BASED ON ALL
MEASUREMENT AND CALCULATION
RESULTS (YES/NO)
RETURN NEXT
RETURN NEXT