User`s manual

7-29
Setting Examples Using the Set Wizard
7
Register a reference image
Move the cursor to " REFERENCE IMG" using
the up and down arrow keys. Then, select "REG"
from the popup menu. The reference image that
you registered is shown in the lower right corner
of the screen.
After the setting is complete, press the ESC key
to return to the "REG COND" screen.
Note: If a reference image is not registered, you
cannot make measurements.
SEARCH ARE (MDL0)
Move the cursor to this line and press the SET key. "SET" will be highlighted. Press the SET key
again and the "RECTANGLE" screen will appear.
Use the same procedures as you used for " REFIMG ARE(MDL0)" to adjust the size and position
of the rectangle defining the search area.
After the setting is complete, press the ESC key twice and return to the "SET WIZARD" screen.
Move the cursor to "NEXT" and press the SET key.
= In this example, the settings on the screens are not changed. Select "NEXT" on each of these
screens to go to the next screen. =
(12) Select whether or not to set the evaluation
conditions for measured results.
Select " YES" and press the SET key.
The "DETAIL" item will appear on the lower part
of the screen. Move the cursor to "DETAIL" and
press the SET key.
STEP6
SELECT INSPECTION PRECISION
1 STANDARD(PIXEL) ■
2
HIGH(SUB-PIXEL) □
RETURN NEXT
Setting the detection precision.
- For details, see page 3-20 in
Function and Operation.
COLOR F C1 BRT
TYPE 00
Start
STEP1：
STEP2：
STEP3：
STEP4：
STEP5：
STEP6：
STEP7：
End
STEP7
1 □
2 ■
SET WIZARD EXIT
[SAMPLE]
PARALLEL+SERIAL+USB
CAPTURE IMG/PARTIAL-IMG
MEAS1/CAM1
MEAS1/F/POS DEVIAT
MEAS1/MEAS CND
MEAS1/DTECT PRECISION
MEAS1/EVALUATION
COMPARE EVALUATION
CONDITIIONS TO MEASUREMENT
RESULTS (YES/NO)
NO
YES
RETURN NEXT DETAIL
1
UP. L (224, 208)
2
LO. R (287, 271)
3
MOVE
4
REFFERENCE IMG
SET=MOVE ESC=BACK SEL=CHNG IMG TRG=FUNC
RED F C1 BRT
RECTANGLE RESET RETURN
X:224 Y:208
CONTRAST SRCH
REG
DISP