User`s guide

MP-70/50 Scoreboard Controller User’s Guide

In situations where you wish to display information for two players on the

team fouls panel, use the above key sequence to enter both player’s statis

tics in the order you want them displayed. This input is double buffered

which means that the first players information will display for 15 seconds

followed immediately by the second player’s information, also for 15 sec

onds.

You can also use the FOULS/PLAYER key to cycle through records in the

team lineups. This allows you to verify player statistics and make correc

tions as necessary. Follow these steps:

1. Press HOME FOULS or VISITOR FOULS. Then press FOULS/

PLAYER. One of the prompts appears, as shown below.

2. Press FOULS/PLAYER again. The statistics for the first player in the

selected team lineup appear on the LCD display. (Player points appear

only if the points memory feature is active.)

3. Press FOULS/PLAYER repeatedly to cycle through the statistics for

each player.

You can correct a player’s statistics as you cycle through the player

records. If the points memory feature is active, type the player number on

the numeric keypad and then press

ENTER. Type the new values at the

ENTER FOULS and ENTER PTS. prompts, pressing

ENTER after each.

If the points memory feature is not active, enter the number of player

fouls. At the PLAYER NO. prompt type the player number and press

ENTER.

Again, correcting an individual player’s statistics does not alter the team

fouls or total score; if those values require correction, you must adjust

them separately.