User`s guide
209
About this guide
This is intended to be used as a portable document that you can use during sport-
ing events to program your MP-70/50’s systems settings and sports-specific infor-
mation. Remember that these settings are stored in your control’s permanent
memory, and under normal circumstances, you should not have to change these
settings.
Programming System Settings
Scoreboard type
Enter the number of your scoreboard. To find the correct number, consult the
“Systems Settings” chapter in the MP-70/50 manual.
MP-69 data output, Conn 3&4 MP-69 data output
Enter NO if your control uses the MP-70 data format. Enter YES if it uses MP-69
data. Consult the “Systems Settings” chapter to determine your control’s format.
Clock at timer
If you pressed YES to the question above, you will be given this prompt. Press YES
if you are using shot timers with a built-in game clock. Otherwise, press NO.
Radio at timer
Again, if you pressed YES to the “Conn...” question above, and you are using the
wireless option, this question will appear. If you are using wireless shot/field tim
-
ers, press YES; otherwise, press NO.
Team names
If you are using the MP-70 data format, you will see this prompt. Press YES if your
scoreboard can display team names and you wish to enter these, otherwise, press
NO.
24-hour time of day clock
Press YES for a 24-hour clock, or NO for a 12-hour clock.
Further wireless system settings prompts
You will see these prompts below if you have a wireless control:
Hipower Transmit
Press YES for full-power radio transmission; press NO for transmission at a reduced
power rate. (Normally, you should select YES).
All scoreboards
Press YES to put the radio transmitter in ALL SCOREBOARDS mode; press NO to
put the transmitter in SELECT mode.
Select channel
Enter your channel number (0 to 15), and press ENTER.
Quick
Reference