User`s guide

MP-70/50 Scoreboard Controller User’s Guide
204
At this point the fully illuminated board will hold for approximately three
seconds. During that time the horn will sound for a brief period. At the
end of the three seconds the scoreboard will blank and start again at the
beginning, continuing to cycle as described above.
Exit TEST mode
To exit, turn the control off. The MP-70/50 control will automatically
return to normal operation the next time it is turned on.
Team name testing
If you have electronic team name areas on your scoreboard, TEST mode
will also test those areas.
When you enter TEST mode, a special signal is sent to the Team Name
electronics. This signal is only sent once. TEST mode will then test the
lamps within the matrix by running a moving horizontal line.
During normal operation, if you want to test your team name areas only.
you can manually enter the “TEST” for the home team name. This, as in
standard TEST mode, will cause a moving horizontal line of lamps to be
displayed in both team name areas. To stop this mode, you need to re-
enter your home team name only.
Note: It is important to have power applied to the
scoreboards and have the data cable attached
before entering TEST mode.