User`s guide

Chapter 15: Wireless
135
• Before establishing communication between a control set to ALL
SCBDS and its intended receiving scoreboards, be sure to have estab
-
lished communication between the controls operating in the SEL
mode and its intended receiving scoreboards. Otherwise, the score
-
boards you intend to run with a control tuned to a particular channel
in the SEL mode will be likely to lock onto the signal from the control
set to ALL SCBDS, and may not respond to the intended SEL mode
control when it is turned on. (For more information, see
“AVOIDING
POTENTIAL PROBLEMS WITH MULTIPLE CONTROLS” ON PAGE 141).
• The scoreboard or shot timer lamp driver circuit card can accommo-
date either conventional control wire hookup or wireless radio
receiver, but is not designated to accept both data transmission meth
-
ods simultaneously.