User`s guide

107
12
Lacrosse is a selection only for scoreboard type 21. Hence, your scoreboard
must be set for scoreboard type 21 in order for you to see the prompt for
Lacrosse when you are in Program Mode. (If your scoreboard is for
Lacrosse, it will be the next question after responding NO to the SOCCER
Y/N prompt).
If lacrosse is not the sport currently selected on the MP-70/50, or if you
want to change the controller’s settings for lacrosse, see
“SELECTING AND
CHANGING SPORTS” ON PAGE 173.
You should also verify that the controller has been programmed to use the
correct scoreboard type and data format as instructed in
“PROGRAMMING THE
SYSTEM SETTINGS” ON PAGE 149.
Sport-specific settings for
lacrosse
When you select lacrosse , the MP-70/50 offers the sport-specific settings
discussed below. When you adjust these settings the MP-70/50 stores your
selections in permanent memory. Your settings become active each time
you select lacrosse in the future.
• The sequence shown on the following pages presents you with all of
the options you could encounter while programming sports-specific
settings. However, these options presented to you may vary, depend
-
ing upon the type of your control (MP-70 or MP-50), the version num-
ber of the firmware in your control, the two-digit board type that
you’ve selected, or your scoreboard model. Hence, not all of the
options outlined in this chapter may appear on your control.
• As you run through the following programming sequence, and you
find the need to back up to a previous programming option earlier in
the sequence, you can back up by selecting
SHIFT+8.
Lacrosse
(board type 21)