Instruction manual

4 - 2

FunctionName

LCD panel with 800×600 dots display. The stylus pen or a finger

is used to enter the operation by directly touching the screen.

This pen is used to enter the operation by touching the touch panel.

Commercially available constant-voltage power supply (24V DC±10%) is

connected here.

TFT LCD panel

(Touch panel)

Monitor input

connector

Connector for direct

monitoring

Power supply

input terminal

Power lamp

Stylus pen

When the equipment is energized, it will be lit.

This connector is connected to the connector of the controller when

directly connect the IV-08MP to the controller (IV-S51M).

This connector is connected to the monitor output connector of the

controller with the monitor cable IV-S50MC2 when connect the IV-08MP

to the controller (IV-S51M) using the monitor cable.

Stylus pen

Holder

How to use the stylus pen

The stylus pen is inserted into the holder at the lower part of the main housing. Pull out the pen to the

right before use. After each use, return the pen into the holder.

(Note)

Use the stylus pen (provided with the equipment) or the USB connected mouse (not provided with the

equipment). Never use the sharp-pointed object such as a pencil or a mechanical pencil which will

damage the display.

Put a string through the hole of the pen and the other end of the string through the hole of the

holder to tie them to prevent the pen from falling off.

Hole for a string

String