User Manual

05/6/7 HT-X15H(H)E7.fm
E-67
ENGLISH
TINSZA064SJZZ
HT-X15H
Advanced Features
To install the surround or centre speaker on the wall
Sharp has designed the surround or centre speaker so you can
hang it on the wall.
Example: Surround speaker
Note:
You can mount the centre speaker in the same way.
CAUTION:
z Make sure to prevent the surround speaker (1.4 kg) or centre
speaker (1.4 kg) from falling when mounting on the wall.
z Before mounting, check the wall strength. (Avoid the veneer plas-
ter or whitewashed wall. The surround or centre speaker may
fall.) If it is not clear, consult with a qualified service technician.
z Check all mounting screws for looseness and that they are
engaged in the surround or centre speaker.
z Mount the surround or centre speaker on the wall with 4 screws.
z Select a good location. If not, accidents may occur or the sur-
round or centre speaker may get damaged.
z Avoid placing on a bed, sofa, water tank, sink and hallway wall.
z SHARP is not responsible for accidents resulting from improper
installation.
1 Make a hole in the wall using
a drill.
2 Drive a wall mount plug into
the hole using a hammer,
until it is flush with the wall
surface.
3 Drive four screws into the wall for each speaker, as shown
in the illustration.
Make sure that both the screw and the wall can support a load
of 3.0 kg.
4 Attach the supplied pattern paper to the wall, and fix 2 sur-
round speaker wall brackets with the supplied 4 screws.
28 mm (1-1/8")
6 mm (1/4")
Wall surface
Surround speaker mounting screw
Wall surface
Surround speaker
wall bracket
Surround speaker
mounting screw
Pattern paper
for surround speaker
5 Remove the pattern paper and tighten the screws. Hang
the surround speaker on the brackets.
Wall surface