User Manual

05/6/7 HT-X15H(H)E2.fm
E-19
ENGLISH
TINSZA064SJZZ
HT-X15H
Preparation for Use
System connections (continued)
 Speaker connection
To prevent accidental short circuits between and terminals,
connect the speaker wires to the speakers first and then to the
subwoofer/amplifier unit.
When connecting speakers, match the colours of the back
label, tube for the speaker wire, and speaker terminal of the
subwoofer/amplifier unit.
Caution:
z
The supplied speakers are exclusively for the HT-X15H. Do
not connect them to other equipment, and do not connect
other speakers to the HT-X15H. It may cause malfunction.
z
Do not mistake the and , and right and left terminals of the
speaker wires. (The right speaker is placed on the right when you
face the subwoofer/amplifier unit.)
z
Do not stand or sit on the speakers. You may be injured.
z
Do not allow any objects to fall into or to be placed in the bass
reflex ducts.
Make sure to leave the AC power lead disconnected when con-
necting the speakers.
z Do not short-circuit the speaker wire. If it
happens with the power on, the protection
circuit is activated and the system enters the
stand-by mode. In this case, check that the
speaker wire is connected correctly before
turning on the power again.
Incorrect
To remove speaker grilles (except for the
subwoofer/amplifier unit):
Make sure nothing comes into contact with the
speaker diaphragm when you remove the speaker
grilles.
Loosen the screws.
Insert the wires and tighten the screws.
2 Connect the wires to the speakers.
1 Route the speaker wires through the holder.
Example: To connect the left front speaker.
Red
Red
Black
Black
Tube (white)
Subwoofer/
amplifier unit
3 Connect the other end to the
subwoofer/amplifier unit.
Tube (white)
Speaker terminal
(white)
1
2
Label (white)
Holder