Owner`s manual

9
1
7
6
5
4
3
2
1
9
2011 April 22
HT-SB600
E-21
Make sure to disconnect all output and input cables
attached to the unit before performing the factory reset.
1. Press the ON/STAND-BY button to enter the power
stand-by mode.
2. Whilst pressing the EQ button, press and hold the
ON/STAND-BY button until “RESET” appears.
Caution:
This operation will erase all data stored in memory
including clock, timer settings and tuner preset.
Periodically wipe the cabinet with a soft cloth.
Caution:
● Do not use chemicals for cleaning (petrol, paint thinner,
etc.). It may damage the cabinet finish.
● Do not apply oil to the inside of each component. It may
cause malfunctions.
When you fail to perform operations properly, the following
messages are displayed on the unit.
(*): Should the same message appear even if the speaker
is unplugged and plugged in, or is set to the stand-by
mode and on again, contact your local dealer where
you purchased the unit.
Troubleshooting chart (continued)
Factory reset, clearing all memory
Maintenance
Cleaning the cabinet
Display Meaning
● Malfunction of the surround
circuit. Place the speaker
away from noise source and
plug the AC power lead into
another wall socket. (*)
(Display blinks)
● When there is no input signal.
Play back the connected
equipment.
● Non-standard signal. Cannot
be recognized.
● Signals other than DOLBY
DIGITAL, DTS, Linear PCM
cannot be recognized.
● Poor connection of the digital
audio input terminal.
● Turn off the unit and check if
the cable is connected
properly.
Timer indicator
(blinks red)
● When the protection circuit is
activated.
(Shown for 2 seconds)
● The cooling fan at the rear of
the unit does not run.
Unplug the AC power lead
and check if foreign objects
get caught around the cooling
fan. (*)
Error indicators and warnings
or
or
or
or