Manual

Error indicators and warnings
When you fail to perform operations properly, the following
messages are displayed on the speaker.
Display
or
or
\1/
/1\
or
\l/
/l\
(Display blinks continuously)
Power indicator (blinks red)
Meaning
• Malfunction of the surround
circuit. Place the speaker away
from noise source and plug the
AC power cord into another AC
outlet. (*)
• When there is no input signal.
Play back the connected
equipment.
• Nonstandard signal. Cannot be
recognized.
Signals other than DOLBY
DIGITAL, DTS, Linear PCM
cannot be recognized.
• Poor connection of the digital
audio input terminal.
Turn off the unit and check if the
cable is connected properly.
• When the protection circuit is
activated.
(*): Should the same message appear even if the speaker is
unplugged and plugged in or is set to the stand-by mode and
on again, contact your local dealer where you purchased the
speaKer.
Specifications
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification changes for
product improvement without prior notice. The performance
specification figures indicated are nominal values of production
speaker. There may be some deviations from these values in
individual speaker.
• General
Power source
Power
consumption
Maximum outpul
power
Speaker
Input terminals
Audio output
terminals
Dimensions
Weight
DO IN 12V -'= 4A:AC/DC adaptor
[AC 100 - 240V ~ 50/60 Hz)
11W
32 W
2.1-way Speaker System
Front Speakers: 1-1/2" (38 mm) Full Range
Subwoofer: 2-1/4" (57 mm) Woofer (x4)
Analog input (LINE 1):
RCA type x 1pair (L/R)
Analog input (LINE 2):
Stereo mini jack _93.5 mm
Coaxial digital input (DIGITAL 1):
RCA type x 1
Optical digital input (DIGITAL 2):
Square type x 1
Subwoofer Pre Out: 10 kOhms
Width:31-1/2" (800 mm)
Height: 3-3/4" (96 mm)
Depth: 2-3/4" (70 mm)
4.10 Ibs. (1.85 kg)
Hq:SB300
23