Manual

HTSB300Remote control
18
• Battery installation
This product contains a CR Coin Lithium Battery which contains
Perchlorate Material - special handling may apply, California
resident& see www.dtsc.ca.gov/hazardouswaste/perchlorate/
1 Insert pin into the hole as shown and pull to open the
battery holder.
remBo?C_
2 Remove the old battery from the battery holder, insert
the new battery and then slide the battery holder back
into the remote control.
Battery holder
_ Battery type
U _ Locking tab
Polarity (+) symbol
Positive (+) side up
Precautions for battery use:
• Remove the battery if the speaker will not be used for long
periods of time. This will prevent potential damage due to
battery leakage.
Caution:
• Do not use rechargeable battery (nickel-cadmium battery,
etc.).
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
• Installing the battery incorrectly may cause the speaker to
malfunction.
Notes concerning use:
• Replace the battery if the operating distance is reduced or if
the operation becomes erratic. Purchase "CR 2025", coin
lithium battery.
• Periodically clean the transmitter on the remote control and
the sensor on the speaker with a soft cloth.
• Exposing the sensor on the speaker to strong light may
interfere with operation. Change the lighting or the direction
of the speaker if this occurs.
• Keep the remote control away from moisture, heat, shock,
and vibrations.
• Test of the remote control
Point the remote control directly at the remote sensor on the
speaker.
The remote control can be used within the range shown
below:
Press the ON/STAND-BY button. Does the power turn on?
Now, you can enjoy your system.
Remote sensor