Manual

I To mount the speaker on the wall I

Caution:

• Be very careful to prevent the speaker [3.88 Ibs. (1.75 kg)]

from falling when mounting on the wall.

• Before mounting, check the wall strength. (Do not put on the

veneer plaster or whitewashed wall. The speaker may fall.) if

unsure, consult a qualified service technician.

• Mounting screws are not supplied. Use appropriate ones.

• Check all wall mount angle screws for looseness.

• Select a good location, if not, accidents may occur or the

speaker may get damaged.

• SHARP is not responsible for accidents resulting from

improper installation,

• Driving screws

SHARP designed the speakers so you may hang them on the

wall. Use proper screws (not supplied). See below for size and

type.

1/8" (3.2 mm)

_ _ 3/8" (9 ram)

I I

Min. 7/8" (22 ram)

• Wall mount angle fixed to the wall

(Horizontal position)

1 Fix the pattern paper to the wall in horizontal position

as below.

44 mm

509 mm

Wall surface 44 29 mm

29 mm Pattern paper

2 Make a hole on the wall following the screw point

marks on the pattern paper by using a drill.

1-1/4" (32 mm)

3/8"(8-9mm)_ <_

Wall surface I

3 Fix a wall mount plug into the hole using a hammer,

until it is flush with the wall surface.

1-1/4" (32 mm)

3/8" (8-9 mm) !_ _-_

Wall surface

HT-SB300

(Continued to the next page)