User Manual

50
Before Using the Wireless router
Wi-Fi settings
If you use the wireless router, you can use mail or Internet
by connecting to access points of your home, corporate
network or public wireless LAN service.
z Packet communication is also available while [Wi-Fi] is set to
On. Wi-Fi connection is prioritized while Wi-Fi connection is set,
but the connection is automatically switched to that of LTE/3G
network once Wi-Fi connection is terminated. Note that packet
communication charges may be incurred in this case.
z Operate access point registration near the access point.
1
In the home screen,▶ [Connection guide
]
2
▶[WPS]
3
Select an access point
z
If you select an access point protected by security, enter the
password (security key) and select [CONNECT].
z
To register access points manually: [Add network]▶enter the
network name▶set security▶[SAVE]
z
When you select an access point and connect to it with a
wrong password (security key), [IP Configuration Failure], [WiFi
Connection Failure], [Authentication problem] or [Connected
(Limited)] is displayed. Confirm the password (security key).
When [IP Configuration Failure] or [Connected (Limited)] is
displayed after entering the correct password (security key),
you may not have acquired the correct IP address. Connect to
the access point again after confirming signal status.
z
As for the manual registration of an access point, this function
supports WEP, WPA/WPA2 PSK and 802.1xEAP as the security
setting.
z
If you connect to an access point which is not connected to the
Internet, [
] is displayed and the communication may be
made by mobile networks, not Wi-Fi connection.
To make Wi-Fi communication by using such an access point,
enable [Using this AP without internet connection] of Advanced
options before connecting to the access point.
 Home screen menu