User Manual

Accessory
Battery (SHBCR1)
Battery Installation
Remove cover

Press and slide as shown.
.
Insert battery

Close cover

Charging
Use specified AC Charger ZTDAA1 (sold
separately) only.
AC 100V Outlet
Blades
AC
Charger
Release
Tabs
1
External
Device Port
Illumination Light
Port Cover
Charger
Connector
Arrows
2
3
Open Port Cover to insert

Charger Connector
Plug AC Charger into AC

outlet
Illumination Light (center LED only)
.
glows red while charging.
Illumination Light goes out when
.
battery is full.
After charging, unplug AC

Charger, then disconnect
handset
Before Using Handset
ii
USIM Card Installation
1
2
3
Notch
Using Tab, pull out Tray

until it clicks
Slide in USIM Card with IC

chip facing up
Push in Tray fully

Insert battery (P.ii)

First power off handset and remove
.
battery.
Do not force USIM Card into/out of
.
handset.
USIM Card must be inserted to use
.
handset.
USIM PIN
4-digit code ( 9999 by default); activate
PIN Entry to restrict usage. Change PIN
as needed.
PIN Lock & Cancellation (PUK Code*)
■
Entering incorrect PIN three consecutive
times activates PIN Lock, limiting
handset use. Enter PUK Code to unlock.
For details, contact SoftBank Mobile
Customer Center, General Information.
Each USIM Card has a unique Personal *
Unblocking Key (PUK Code). Do not
disclose it to unauthorized persons.
iii