MODEL UX-K01 t se d n a sH lesANUAL d r o z C TION M 2.4GH A OPER Charge the battery for about 10 hours before initial use.
setup.fm Page 1 Friday, April 5, 2002 4:28 PM Introduction To use the UX-K01 cordless handset, you must have a UX-CC500 fax machine. Thank you for purchasing a UX-K01 cordless handset. Accessories Battery cover Battery pack AC adapter Cordless handset charger Specifications Frequency 2.4 GHz (2.405 to 2.475 GHz) Dimensions Width: 1.8" (46 mm) Depth: 1.7" (42 mm) Height: 7.1" (180 mm) (not including antenna) Weight Approx. 0.3 lbs. (115 g) (without battery) Battery 3.
setup.fm Page 2 Friday, April 5, 2002 4:28 PM Important safety information Do not disassemble this product or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel. Do not this product near water, or when you are wet. For example, do not use this product near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Take care not to spill any liquids on the product.
setup.fm Page 3 Friday, April 5, 2002 4:28 PM Connecting the Cordless Handset Charger 1 Connect the AC adapter to the cordless handset charger. 2 Plug the AC adapter into a standard 120 V AC outlet. Place the cord in the holders. Important: Never cover the charger and AC adapter with a blanket, cloth, or other material. Excessive heating may result, causing a fire. Installing and Charging the Battery 1 Connect the battery connector ➊, and then place the battery pack in the cordless handset.
setup.fm 3 Page 4 Friday, April 5, 2002 4:28 PM Place the cordless handset in the charger with the dial pad facing forward. • Important! The dial pad must face forward, or the battery will not charge. • The battery charges automatically while the cordless handset is in the charger. While charging, the display shows CHARGING. • When charging is completed the first time, the display shows PLEASE REGISTER. After the handset is registered, the display shows IN CHARGER while in the charger.
setup.fm Page 5 Friday, April 5, 2002 4:28 PM Registering the Cordless Handset After the initial charging, the cordless handset display shows: PLEASE REGISTER 1 On the cordless handset, hold down INTER COM 2 To use the cordless handset, you must first register it using the fax machine. until the display at right appears. Press 1 on the cordless handset.
setup.fm Page 6 Friday, April 5, 2002 4:28 PM The fax machine is identified by the number “0”, and the cordless handset that was included with the fax is identified by the number “1”. Entering a Name for the Cordless Handset Enter a name for the cordless handset in the fax machine. ♦ The fax machine will transmit the name that you enter to your cordless handset. 1 Press FUNCTION once and the fax machine. 3 times on Fax machine display: ENTRY MODE 2 Press once and 3 Press once.
setup.fm 6 Page 7 Friday, April 5, 2002 4:47 PM Enter the name by pressing number keys for each letter as shown in the chart below. Up to 10 characters can be entered. Example: BILL = 22 444 555 555 G= N= A= H= O= V= B= I = P= W= SPACE = U= C= J= Q= X= D= K= R= Y= E= L= S= Z= F= M= T= ♦ To enter two letters in succession that require the same key, press after entering the first letter. ♦ To clear a mistake, press SPEAKER .
setup.fm Page 8 Friday, April 5, 2002 4:28 PM Maintenance Replacing the Cordless Handset Battery If LOW BATTERY continues to appear in the cordless handset display after the battery has been charged for 10 hours, replace it with the following battery: Replacement battery: Use only a Sharp UX-BA01 battery (3.6 V Ni-MH battery, capacity: 850 mAh) Caution: There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer.
setup.fm Page 9 Friday, April 5, 2002 4:28 PM Deleting a cordless handset If you wish to stop using a cordless handset, follow these steps to delete it (cancel the registration in the fax machine). 1 On the cordless handset, hold down INTER COM 2 until the display at right appears. Press 2 on the cordless handset.
setup.fm Page 10 Friday, April 5, 2002 4:28 PM FCC regulatory information This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
warranty‑cordless2.
warranty‑cordless2.fm Page 2 Friday, April 5, 2002 4:31 PM IMPORTANT SERVICE INFORMATION If a Problem Occurs Most operational questions can be answered by referring to this "Setup Guide and Operation Manual" Also, for your convenience, you will find answers to most frequently asked questions on our website at www.sharpusa.com/, or by sending e-mail to faxsupport@sharpsec.com. Should you require further assistance, call 1-877-794-8675; a Customer Relations Specialist will assist you.
back.fm Page 139 Friday, April 5, 2002 4:31 PM SHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey 07430-2135 http://www.sharpusa.com SHARP CORPORATION FOR YOUR RECORDS Please record the model number and serial number below, for easy reference, in case of loss or theft. These numbers are located on the rear side of the unit. Space is also provided for other relevant information.
