Operation Manual

136 Settings
Assigning the Pictures
Pictures can be displayed when turning the power on or
off, when receiving an incoming call, or when
operating the alarm.
Pictures taken by a digital camera or images
downloaded from a WAP site can be used.
To Set Built-in Pictures
1. Perform steps 1 to 3 in “Opening the Phone Settings
Screen” on page 129.
2. Press a or b to highlight “Main Display”, then
press to select.
3. Press a or b to highlight “Assign Pictures”, then
press to select.
4. Press a or b to highlight the screen to set the
picture, then press to select.
5. Press a or b to highlight “Animation 1” or
“Animation 2”, then press to select when you
select “Power On” or “Power Off” in step 4.
Or press a or b to highlight “Pattern 1” or
“Pattern 2”, then press to select when you select
“Incoming” or “Alarm” in step 4.
The selected animation or picture is displayed.
6. Press to set.
Tip
• To cancel the picture setting, select “Default”, then
press in step 5.
To Set My Pictures
1. Perform steps 1 to 3 in “Opening the Phone Settings
Screen” on page 129.
2. Press a or b to highlight “Main Display”, then
press to select.
3. Press a or b to highlight “Assign Pictures”, then
press to select.
4. Press a or b to highlight the screen to set the
picture, then press to select.
5. Press a or b to highlight “My Pictures”, then
press to select.
6. Press a or b to highlight “Handset Memory” or
“Memory Card”, then press to select.
The file name of the pictures that are registered in
the selected memory is displayed.