Operation Manual

128 Contacts
Setting the Charge Limit
This function is useful if you wish to make sure you do
not exceed a certain charge limit.
1. Perform steps 1 to 3 in “Checking the Cost of the
Last Call” on page 127.
2. Press a or b to highlight “Max Cost”, then press
to select.
3. Press a or b to highlight “Set Limit”, then press
to select.
4. Enter your PIN2 code, then press .
5. Enter a value, then press .
To enter a decimal point, press R.
Resetting All Call Costs
1. Perform steps 1 to 3 in “Checking the Cost of the
Last Call” on page 127.
2. Press a or b to highlight “Clear Costs”, then press
to select.
3. Enter your PIN2 code, then press .
4. Press A [Yes].
The Call Costs are reset to zero.
To cancel resetting, press C [No] in step 4.
Checking the Residual Credit
1. Perform steps 1 to 3 in “Checking the Cost of the
Last Call” on page 127.
2. Press a or b to highlight “Residual Credit”, then
press to select.