User guide

140 Settings
Assigning the Pictures
Pictures can be displayed when turning the power on or
off, when receiving an incoming call, or when
operating the alarm.
Pictures taken by a digital camera or images
downloaded from a WAP site can be used.
To Set Built-in Pictures
1. Perform steps 1 to 4 in “To Set Built-in Animation
or Pictures of the Main Display” on page 136.
2. Press or to highlight “Assign Pictures”, then
press to select.
3. Press or to highlight the screen to set the
picture, then press to select.
4. Press or to highlight “Animation 1” or
“Animation 2”, then press A [View].
Or press or to highlight “Pattern 1” or
“Pattern 2”, then press A [View] when you select
“Incoming” or “Alarm” in step 3.
The selected animation or picture is displayed.
5. Press to set.
Tip
• To cancel the picture setting, select “Default”, then
press in step 4.
To Set My Pictures
1. Perform steps 1 to 4 in “To Set Built-in Animation
or Pictures of the Main Display” on page 136.
2. Press or to highlight “Assign Pictures”, then
press to select.
3. Press or to highlight the screen to set the
picture, then press to select.
4. Press or to highlight “My Pictures”, then
press to select.
The file name of the pictures that are registered in
the Saved Pictures is displayed.
5. Press or to highlight the picture, then press
to select.
The selected picture is displayed.
6. Press , , or to specify the area you
wish to display, then press .
Note
• Some pictures cannot be used because of their
picture and data types.