Specifications
04/1/28 CX-GD5200V_EN2.fm
E-34
ENGLISH
GX-CD5200V
Tape Recording
Beat cancel switch:
If a whistling noise occurs when recording from an MW, SW1 or SW2
station, set the BEAT CANCEL switch to A, B or C, whichever gives
the best reception.
■ Recording from the built in microphone
Notes:
● Do not connect anything to the Mixing Mic socket.
● Monitoring of the recording is not possible.
● Recording from the built-in microphone is not in stereo.
■
Mixing recording from microphone and tape
Notes:
● Place the microphone about 10 - 15 cm (4-6") away from the
source.
● If the howling occurs, lower the volume or move the microphone
as far as possible from the speaker.
● To record the microphone signals only, load a cassette into the
TAPE 2 cassette compartment, set the FUNCTION to TAPE 2.
Press the button and then press the TAPE 2 button.
Caution:
When not using the microphone, remove the microphone plug from
the Mixing Mic socket.
■ Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1 Press the TAPE (1 2) button until TAPE 2 appears on the
display.
2 Load a cassette into the TAPE 2 cassette compartment with
the side A facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3 Press the button to choose one side or both sides.
… To record on both sides.
… To record on only one side.
4 Press the button.
Recording will be paused.
5 Press the button again to begin recording on side A or
button for side B.
1 Connect the microphone plug to the Mixing Mic socket.
2 Press the TAPE 1 function.
3 Load a blank tape into the TAPE 2 cassette compartment.
Insert a pre-recorded cassette into the TAPE 1 cassette
compartment.
4 Press the button.
5 Press the button of TAPE 1.
1 Press the ON/STAND-BY button to turn the power on.
2 Load a pre-recorded cassette into the TAPE 1 cassette
compartment. Insert a blank tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is the same length as
the master tape.
3 Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
The reverse mode will be set to
"".
Downloaded from www.Manualslib.com manuals search engine
Downloaded From Disc-Player.com Sharp Manuals