User Manual
E-11
PLAYPLAY
RECORD
DUBBING
SPEED
FUNCTION
VOLUME
MIX MIC
,
,
PLAY/PAUSE
USING EXTERNAL UNITS
PHONES
■ Mixing from a microphone and TAPE
To listen to or record mixed signals from an external mi-
crophone and TAPE.
1 To protect the speakers from shock noise and to avoid dis-
turbing noises, set the VOLUME control to minimum.
● Be sure that the microphone has a 3.5 mm (1/8") diameter
plug, and is of 600 ohms impedance; if not, use an appro-
priate adaptor.
2 Connect the microphone plug to the MIX MIC socket.
3 Set the FUNCTION switch to TAPE.
4 Load a cassette into the TAPE 1 or TAPE 2 cassette com-
partment.
5 Press the PLAY button of the TAPE 1 or TAPE 2.
6 Adjust the volume of the audio source and the microphone
using the VOLUME control.
For mixing recording
1 Perform steps 1 - 3 above.
2 Load a blank tape into the TAPE 1 cassette compartment.
Insert a prerecorded cassette into the TAPE 2 cassette
compartment.
3 Set the DUBBING SPEED switch to NORMAL.
● Mixing recording is not possible if the DUBBING SPEED
switch is set to HIGH.
4 Press the RECORD button of TAPE 1.
5 Press the PLAY button of TAPE 2.
Notes:
● Place the microphone about 10-15 cm (4-6") away from
the source.
● If howling occurs, lower the volume or move the microphone
as far as possible from the speakers.
● To record the microphone signals only, load a cassette into
the TAPE 1 cassette compartment, set the FUNCTION
switch to TAPE and the DUBBING SPEED switch to NOR-
MAL. Then, press the RECORD button.
Caution:
● When not using the microphone, remove the microphone
plug from the MIX MIC socket.
■ Mixing from a microphone and a CD
To listen to or record mixed signals from an external mi-
crophone and CD.
1 To protect the speakers from shock noise and to avoid dis-
turbing noises, set the VOLUME control to minimum.
● Be sure that the microphone has a 3.5 mm (1/8") diameter
plug, and is of 600 ohms impedance; if not, use an appro-
priate adaptor.
2 Connect the microphone plug to the MIX MIC socket.
3 Set the FUNCTION switch to CD.
4 Load a compact disc into the CD compartment.
5 Press the PLAY/PAUSE button on the CD.
6 Adjust the volume of the audio source and the microphone
using the VOLUME control.
For mixing recording
1 Perform steps 1 - 4 above.
2 Load a blank tape into the TAPE 1 cassette compartment.
3 Set the DUBBING SPEED switch to NORMAL.
● Mixing recording is not possible if the DUBBING SPEED
switch is set to HIGH.
4 Press the RECORD button of TAPE 1.
5 Press the PLAY/PAUSE button on the CD.
■ Headphones
● Before plugging in or unplugging the headphones, make
sure the volume level is reduced.
● Be sure your headphones have a 3.5 mm (1/8") diameter
plug and are between 16 ohms and 50 ohms impedance.
The recommended impedance is 32 ohms.
● Connect the headphones plug to the PHONES socket. The
speakers will be automatically disconnected. Adjust the
volume by using the VOLUME control.