User Manual

E-9
RECORDING
PLAY PLAYPAUSE
DIRECTION
RECORD
FUNCTION
TUNING
FINE TUNING
ABC
BEAT CANCEL
TAPE 1
PLAY/PAUSE
Built-in microphone
■ Recording from the CD player
1 Set the FUNCTION switch to CD.
● Load the disc to be recorded.
2 Load a cassette into the TAPE 1 cassette compartment.
3 Press the RECORD button.
4 Press the PLAY/PAUSE button on the CD.
To stop recording:
Press the STOP/EJECT button.
The tape will stop.
Note:
● If the STOP or PLAY/PAUSE button on the CD player is
pressed whilst recording, or if the CD comes to its end, the
tape deck will not stop.
To record a specific track:
Press the UP or DOWN button on the CD player until the de-
sired track number is displayed, then start recording.
■ Recording from the radio
1 Tune in to the desired station. (See page 7.)
2 Load a cassette into the TAPE 1 cassette compartment.
3 Press the PAUSE button of TAPE 1.
4 Press the RECORD button of TAPE 1, which also engages
the PLAY button.
5 Press the PAUSE button of TAPE 1 again to begin record-
ing.
Beat cancel switch:
If a whistling noise occurs when recording from an MW, SW1
or SW2 station, set the BEAT CANCEL switch to A, B or C,
whichever gives the best reception.
■ Recording from the microphone
1 Set the FUNCTION switch to TAPE.
2 Set the DUBBING SPEED switch to MIC.
3 Load a cassette into the TAPE 1 cassette compartment.
4 Press the PAUSE button of TAPE 1.
5 Press the RECORD button of TAPE 1, which also engages
the PLAY button.
6 Press the PAUSE button again to begin recording.
Notes:
● Do not connect anything to the MIX MIC socket.
● Monitoring of the recording is not possible.
● Recording from the built-in microphone is not in stereo.
● When recording important selections, be sure to make a
preliminary test to ensure that the desired material is being
properly recorded.
● The VOLUME, X-BASS, SURROUND and GRAPHIC
EQUALIZER controls may be adjusted with no effect to the
recorded signal (Variable Sound Monitor).
● Metal and CrO
2
tapes cannot be used for recording.