R FU-60SE-K NEDERLANDS ITALIANO ESPAÑOL AIR PURIFIER OPERATION MANUAL Floor / Tabletop type “Plasmacluster” is trademark of Sharp Corporation.
TERMS OF GUARANTEE Sharp Electronics (UK) Ltd. (“Sharp”) guarantees to provide for the repair, or at its option the replacement, of this product subject to the conditions listed below:1. This guarantee shall only apply to faults which are due to inferior workmanship or materials. It does not cover faults or damage caused by accident, misuse, fair wear and tear, neglect, tampering with the product, or repair other than by a Service Facility appointed by Sharp. 2.
ENGLISH FEATURES Cluster Ion Balance Control The unit controls the ratio of Negative cluster ions and Positive cluster ions depending on the condition of the room. • Clean mode Approximately the same amount of Positive and Negative cluster ions are discharged. This mode is effective for reducing some airborne mold. • Ion control mode It is said that plenty of Negative cluster ions exist in places such as waterfalls or forests in natural environment.
SAFETY PRECAUTIONS • Do not use the unit if the power cord or plug is damaged or the connection to the wall outlet is loose. Electrical shock, short circuit and/or fire may occur as a result. • Do not damage, break, coat, forcefully bend, pull, twist, bundle, pinch or place heavy objects on the power cord. If the power cord is damaged, fire and/or electrical shock may occur as a result. • Use AC 220-240V only. Fire and/or electrical shock may occur as a result. • Do not modify.
CAUTIONS CONCERNING THE USAGE OF THIS PRODUCT • Do not block the intake and Air Outlet. • Do not use the unit near or on hot objects, such as a stove, etc. Also, do not use the unit where it may come into contact with steam. • Do not use the unit on its side. Deformation, malfunction and/or overheating of the motor may occur as a result. • Do not install when there is generation of lampblack, such as in a kitchen. • Do not use detergent when cleaning the unit. The unit surface may become damaged or cracked.
NAMES OF PARTS AUTO operation lamp MAIN UNIT DISPLAY OFF timer display lamps (set using remote control) Filter lamp If the Filter lamp is lit, the Active carbon filter needs to be cleaned. CLUSTER ION LAMP Cluster ion operation is selected using the remote control. Blue light When the cluster ion operation is in Clean mode or AUTO cluster ion mode and the air in the room is dirty, this light turns on and the unit will operate in Clean mode.
Pollen mode operation lamp CLEAN-SIGN The color changes when the air is dirty. Clean (green) Slightly dirty (orange) Very dirty (red) ABOUT THE CLEAN-SIGN Remote control receiver • The sensor displays a CLEAN-SIGN lamp depending on relative changes to the environment from the time the power plug is inserted into the wall outlet and thereafter.
NAMES OF PARTS BACK Ion wide louver Handle • The output direction of the purified air can be changed to the directions indicated by the arrows. • Set the output direction as desired.
PREPARATION INSERTING BATTERIES IN THE REMOTE CONTROL 1 Remove the back cover 2 Insert batteries 3 Close the back cover Press and slide the back cover to remove. Insert batteries with shown below. and About the batteries • The battery life is about 1 year. • Replace the batteries when the remote control becomes inoperative. • Incorrect usage of the batteries may cause battery fluid leakage and/or damage.
PREPARATION • Be sure to remove the power plug from the wall outlet. Be sure to remove the power plug from the wall outlet. INSTALLING THE FILTERS To maintain the quality of the filters, they are installed in the main unit within plastic bags. Be sure to remove the filters from the plastic bags before using the unit. 1 Remove the filters 1 Place the unit facing up. Lay the unit on a table, etc., while making sure not to pinch the power cord on the rear of the unit.
2 Install the filter Tabs Remove the HEPA filter from 1 the plastic bag and mount it within the Filter frame with the “FRONT” sign facing up. HEPA filter Insert so that the tabs on the HEPA filter are facing toward you. Proper operation cannot be achieved when installing the filter backwards. Filter frame the Active carbon fil2 Remove ter from the plastic bag and Active carbon filter mount it within the Filter frame.
OPERATION For the first 30 seconds after the power plug is inserted into the wall outlet, the unit will check the condition of the air. If operation is set to ON during this time, the CLEANSIGN lamp will alternately flash green, orange and red.
Operations available with remote control REMOTE CONTROL OPERATION • To start operation, press the POWER ON/OFF button. A short beep will sound and operation will start in AUTO operation (fan level). AUTO cluster ion mode is selected for cluster ion operation. • To stop operation, press the POWER ON/OFF button again. A long beep will sound and operation will stop.
GUIDE FOR OPERATION GUIDE FOR ODOR SENSOR • In addition to odor such as cigarette smoke and pet odor, the odor sensor also responds to the following. • Insecticide, cosmetics, spray, alcohol. • Sudden changes in temperature or humidity. • When the unit is in automatic operation and cosmetics or the like are used in a closed room, it is normal for the sensor to respond by increasing the air flow. If this is not desirable, change the sensitivity of the sensor.
CARE AND MAINTENANCE (To maintain the best performance of this product, please clean the unit periodically.) When cleaning, be sure to remove the power plug from the wall outlet. In addition, never handle the power plug with wet hands. Electrical shock and/or bodily injury may occur as a result. MAIN UNIT For soiling on the main unit and the installed floor / table surface, clean as early as possible. Stubborn dirt may be hard to remove.
CARE AND MAINTENANCE GUIDE FOR LIFE OF FILTERS The filter replacement period is indicated by the Filter lamp. (The lamp will light up in about 5 years, when using the unit for 12 hours daily.) • The operation hours are saved in memory even when removing the power plug for transportation to another room, etc. The Filter lamp is to be used only as a guide. If dust or odors cannot be removed easily, replace the filters.
TROUBLESHOOTING Before calling for repair, check the symptoms below for possible remedies, since the problem may not be a malfunction of the unit.
SHARP CORPORATION OSAKA, JAPAN TINSEA002KKRZ 03EO JP 1
