FP-J50J AIR PURIFIER OPERATION MANUAL “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. * The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm3, which is measured around the center of a room applicable floor area (at 1.2 m height above the floor) when the product is placed close to a wall at the MED mode setting. FP-J50J_2nd.
Please read before operating your new Air Purifier The air purifier draws in room air through the air inlet, circulates it through a Pre-Filter, a Deodorizing Filter and a HEPA Filter inside the main unit, and then discharges it through the air outlet. The HEPA Filter can remove 99.97 % of dust particles as small as 0.3 microns that pass through the filter and also helps absorb odors. The Deodorizing Filter gradually absorbs odors as they pass through the filter.
FEATURES Unique Combination of Air Treatment Technologies Triple Filtration System + Plasmacluster TRAPS DUST* Pre-Filter traps dust and other large airborne particles. CONTENTS IMPORTANT SAFETY INSTRUCTIONS ................ 2 CARE AND MAINTENANCE .................................. 4 REPLACEMENT ..................................................... 5 PART NAMES ......................................................... 6 DECREASES ODORS Deodorizing filter absorbs many common household odors.
IMPORTANT SAFETY INSTRUCTIONS Always follow basic safety precautions when using electrical appliances, including the following: • Be careful not to damage the power cord. Failure to do so can cause electric shock, heat generation, or fire. • Do not remove the plug when your hands are wet. • Do not use this main unit near gas appliances or fireplaces. When the main unit is operated with gas appliances in same room, Ventilate a room periodically, otherwise it may cause Carbon monoxide poisoning.
CAUTIONS CONCERNING OPERATION INSTALLATION GUIDELINES • Avoid locations where the sensors are exposed to direct wind. Doing so can cause the main unit to malfunction. • Avoid locations where furniture, fabrics, or other objects can come in contact with the main unit and interfere with the intake and outtake of air. • Avoid locations where the main unit is exposed to condensation or drastic changes in temperature. Appropriate room temperature is between 0 – 35 ºC.
CARE AND MAINTENANCE Always be sure to remove the power plug from the wall outlet. To maintain optimum performance of this air purifier, please clean the main unit including the filter periodically. Be sure to disconnect the power cord from the wall outlet before performing any maintenance. BACK PANEL (Pre-filter) Gently remove dust from the back panel, using a vacuum cleaner attachment or similar tool. Back Panel CAUTION Do not apply excessive pressure, when scrubbing the back panel.
MAIN UNIT Wipe with a dry, soft cloth For stubborn stains or dirt, use a soft cloth dampened with warm water. CAUTION • Do not use volatile fluids Benzine, paint thinner, polishing powder, etc., may damage the surface. • Do not use detergents Detergent ingredients may damage the main unit. Always be sure to remove the power plug from the wall outlet.
PART NAMES FRONT 3 2 4 6 5 7 8 1 9 10 Cleanliness Monitor Blue Indicates the air purity of the room in 3 levels with color changes. Clean Orange Red Impure BACK 12 11 13 14 15 19 18 17 16 1 Main Unit 9 2 Air Outlet 10 Cleanliness Monitor OFF TIMER Button, Indicator Light (white) 11 Handle (Press 3 sec.) Filter Reset Button, Indicator Light (orange) Dust Sensor Filter MODE Button, Indicator Light (white) 12 13 14 Deodorizing Filter (Press 3 sec.
Always be sure to remove the power plug from the wall outlet. FILTER INSTALLATION To maintain the quality of the filter, it is installed in the main unit and packed in plastic bag. Be sure to remove the plastic bag from the filter before using the main unit. Remove the Back Panel. 1 3 Place the Filter within the main unit. Do not install the filter backwards or the main unit will not operate properly. Pull Deodorizing Filter Remove the plastic bag from the Filter.
OPERATION START/STOP START STOP • Select the desired fan speed. • When the main unit starts operation, the operation starts in the previous mode it was operated in. (Except CLEAN ION SHOWER mode) CLEAN ION SHOWER The main unit releases Plasmacluster ions with strong airflow and collects dusts while decreasing static electricity for 10 minutes. After that, the DUST sensor sensitivity is automatically increased and quickly detects impurities and clean the air powerfully for 50 minutes.
LIGHT CONTROL You can set the Cleanliness Monitor / Plasmacluster Ion Light to OFF when they are lighting up. (with the main unit ON) 1 NOTE • If the CLEAN ION SHOWER Button is not pushed within 8 seconds, the setting will be saved automatically. • When the main unit starts operation, the operation starts in the previous mode it was operated in. more than 3 sec. AUTO 2 AUTO DIM OFF Light automatically switches ON or OFF based on room brightness.
TROUBLESHOOTING Before calling for service, please review the Troubleshooting list below, since the problem may not be a main unit malfunction. SYMPTOM REMEDY (not a malfunction) Odors and smoke are not removed. • Replace the filters if they appear to be heavily soiled. (Page 5) • Check if the plastic bag is removed from the filter. (Page 7) The Cleanliness Monitor illuminates blue even when the air is impure. • The air could be impure at the time the main unit was plugged in.
SPECIFICATIONS Model FP-J50J Power supply 220 - 240 V 50 - 60 Hz Fan speed Adjustment MAX MED SLEEP*2 Fan Speed (m3/hour) 306 186 48 ~ 120 Noise Level (dBA)*1 51 39 15 ~ 30 Rated Power (W) 39 14 4.5 ~ 7.5 Standby Power (W) 0.9 2 Recommended Room Size (m )* 3 ~ 40 High density Plasmacluster ion recommended room size (m2)*4 ~ 23 HEPA*5 / Deodorizing Filter type Cord Length (m) 2.0 Dimensions (mm) 390 (W) x 270 (D) x 583 (H) Weight (kg) 6.
FOR CUSTOMER ASSISTANCE WARRANTY Consumer Electronic Products Congratulations on Your Purchase! This Sharp product is warranted against faults in material and manufacture for the period as stated in the table below. If service is required during the warranty period, please contact your nearest Sharp Approved Service Centre. These repairs would be carried out at no charge to the owner, subject to the conditions specified herein.
FOR LOCATION ENQUIRIES WITHIN AUSTRALIA REGARDING YOUR LOCAL SHARP APPROVED SERVICE CENTRE Customer service helplines 1300 742 770 (calling within Australia) Monday - Saturday, 9am - 6pm Open Monday to Saturday except on public holidays. Distributed by Tempo (Aust) Pty Ltd PO Box 132 Frenchs Forest NSW 1640 Australia info@tempo.org For an electronic copy of this manual, please contact our after sales support centre.
SHARP CORPORATION OSAKA, JAPAN TINS-B305KKRZ FP-J50J_2nd.
