Service manual

FO-DC550 USER PROGRAM 12 - 3
7 PRINT SELECTION 1: ALWAYS PRINTS
2: ERROR ONLY
3: NEVER PRINTS
3: RECEPTION
Select the condition for printing reports on received faxes.
1: ALWAYS PRINTS
2: ERROR ONLY
3: NEVER PRINTS
4: IMAGE MEM. PRINT
Enable printing of the original image on transaction reports.
8 RECALL TIMES
BUSY
00 – 14 (02) Set the number of recall attempts that are made when the line is busy.
9 RECALL TIMES
ERR
0 – 1 (1) Set the number of recall attempts that are made when a communication error occurs.
10 RECALL INT. BUSY 01 – 15 min. (03 min.) Set the interval between recall attempts when the line is busy. 1 to 15 minutes can
be selected.
11 RECALL INT. ERR 00 – 15 min. (01 min.) Set the interval between recall attempts when a communication error occurs. 0 to 15
minutes can be selected.
12 SECURITY SELECT 1: ON
2: OFF
Enable the polling security function.
13 FAX REMOTE
NUMBER
0 – 9 (5) Set the 1-digit number used to activate remote fax reception.
14 REMOTE
RECEPTION
1: ON
2: OFF
Enable the remote reception function.
15 FAX SIGNAL RCV 1: ON
2: OFF
Enable automatic fax reception when a fax tone is heard after answering a call on an
extension phone.
16 RCV REDUCE 1: ON
2: OFF
When a fax is received that is larger that the printing paper, enable reduction of the
fax to the size of the paper to avoid the fax being cut off.
17 BEEP LENGTH 1: 3 SEC
2: 1 SEC
3: NO BEEP
Set the length of the beep that sounds when fax transmission or reception ends.
18 RINGER VOLUME 1: OFF
2: LOW
3: MIDDLE
4: HIGH
Set the volume of the ringer.
19 BEEPER VOLUME 1: OFF
2: LOW
3: MIDDLE
4: HIGH
Set the volume of the beep that sounds when a key is pressed.
20 DIAL MODE 1: TONE
2: PULSE
Set the dial mode for the type of line you are on.
21 DISTINCTIVE RING 1: OFF
2: STANDARD
3: PATTERN 1
4: PATTERN 2
5: PATTERN 3
6: PATTERN 4
7: PATTERN 5
Set the ring pattern for distinctive ring.
22 INDEX PRINT 1: ON
2: OFF
Enable printing of a black mark (index) at the top of each received fax page.
23 DATE&TIME
FORMAT
1: 12 HOUR
2: 24 HOUR
1: TIME FORMAT
Select 12-hour or 24-hour format for the time set in the machine.
1: MMDDYYYY
2: DDMMYYYY
3: YYYYMMDD
2: DATE FORMAT
Set the format of the date in the display and in printouts.
24 PRINT HOLD MODE 1: ON
2: OFF
When this mode is enabled, received faxes are held in the memory of the machine
instead of being printed out. To print received faxes, the passcode that was
programmed using "25: PRINT PASSCODE" must be entered. This mode is used to
ensure that received faxes are not misplaced or taken from the paper output tray by
another person.
25 PRINT PASSCODE 1: SET
2: CLEAR
This setting is used to program the passcode that is required when "24: PRINT
HOLD MODE" is enabled.
26 2-SIDED RX 1: ON
2: OFF
Print on both sides of the paper when a multi-page fax is received.
27 TRAY SELECTION
(When the 250-sheet
paper feed unit is
installed.)
1: AUTO
2: TRAY 1
3: TRAY 2
Set the tray for printing received faxes.
Program
number
Program name
Setting codes
(factory default setting
appears in bold)
Explanation