Service manual

FO-4700U
FO-47UC
3 – 26
19
Paper take-up ass’y, Paper take-up sensor (PS1)
Fig. 19
Paper take-up
assy
When mouting the Paper
take-up assy, make sure
the lower left post of the
assy is anchored in the
plastic piece attached to
the left frame.
To remove, pull the right side of the Paper
take-up assy out, then slide the assy out
to the right.
Top view
(2)
(1)
1. Turn the machine over on its back side and then remove the Paper
take-up ass’y. (5 screws, 1 connector)
Paper take-up sensor
(PS1)
2. Remove the Paper take-up assembly.
3. Remove the Paper take-up sensor (PS1) and unplug the connector.