Service manual

FO-4700U

FO-47UC

3 – 23

Fig. 15

Spacer

Fusing unit

Backup roller

Fusing entrance guide

(1)

(2)

(3)

voltage mark

3. Remove two screws.

4. To release the upper unit, push in the clip in the upper mid section of

each end, then free the button to the side of each end.

5. Remove the Backup roller.

6. Remove the Fusing entrance guide.

(1) Push the guide to the left.

(2) Pull the right end out.

(3) Pull out the left end.

7. Remove the Lamp holder. (2 screws)

8. Pull out the Heater lamp.

NOTE:

• When reinstalling the lamp, position the voltage mark on the

fusing drive gear side. Be sure not to touch the lamp surface

with bare hands.

Replace the Fusing unit about every 50,000 sheets of print.

1. Remove the Rear cover. (6 screws)

2. Remove the Fusing unit. (4 screws, 3 connectors)

NOTE:

• Once the Fusing unit is removed, use the following instructions

to make repairs when image quality problems or parts failure

occurs.

Rear cover, Fusing unit (1/2)