Service manual

1 – 11
FO-4700U
FO-47UC
7. Instructions for installing the FO-47UC paper
cassette
Insert the connector wires into their holder in the edge of the
base plate of the unit, and then insert the connector into its socket
on the printed circuit board (the white connector wire should be on
the right).
Secure the cassette to the base plate of the unit with the 4 screws
as shown.
Reattach the cassette side cover.
Reattach the rear cover, securing it with the 4 screws.
Close the print compartment cover and reattach the document
OUT tray.
Important! Be sure to turn off the power and unplug the power
cord before proceeding.
Remove the document OUT tray (if attached). Press the
green release and open the print compartment cover.
Remove the screws (4) that secure the rear cover and then
remove the rear cover.
Pull down on the bottom edge of the side cover to release it from
its catch, and then rotate the bottom edge up slightly (no more than
30°). Rehold the cover at the sides, bend it in slightly, and remove it.
Pull out the connector so that it hangs over the edge of the
cassette. Place the unit on the cassette, making sure that the
studs go into the holes.