Service manual

1 – 8
FO-4700U
FO-47UC
1) Make sure your computer and the fax machine are both turned off.
2) Connect one end of the cable to the port on the fax machine.
Snap the clips on each side of the port onto the cable connector to
secure it.
3) Connect the other end of the cable to the parallel port on the back
of your computer.
4) Press the panel keys as shown to set Option Setting 31(PC
Interface Mode) to ON.
• Before you can use the fax machine as a printer, you must also
install the printer software. To install the software, see the doc-
umentation that accompanies it.
Note: The message PC PRINTING will appear in the display when
the fax machine prints a print job from your computer. While this
message appears, you will not be able to use the operation panel of
the fax machine.
Verification Stamp (Option : FO-45VS)
Note: This function is available as an option. Consult your dealer if
you wish to use it.
When transmitting a document, you can have your fax stamp each
document page as it is scanned. After scanning, you can check to
see if all documents have been stamped to verify that no double feeds
occurred. (A double feed is when two pages are fed through the
scanner at once, which means that one of the pages is not scanned.)
To use this function, have your dealer install the Verification Stamp
option, and then set Option Setting 29 to ON.
4
FUNCTION
3
1
1
STOP
STOP
POWER
Turn
off
4.Loading Printing Paper
You can load up to 250 sheets of letter or legal paper (max. 20 lbs.)
in the paper tray. You can load up to 500 sheets of paper in the
paper cassette.
The paper cassette is available as an option.
To have the cassette installed, consult your dealer.
Note: To use A4 paper in the paper cassette, you must have a
service technician adjust the cassette.
Loading paper in the paper tray
1) Remove the received document tray.
2) If you are loading legal paper, grasp the end of the paper tray and
pull it out.
3) Insert a stack of paper into the tray, print side up.
• If you loaded letter paper, make sure the end of the tray is
pushed in. Otherwise a size error will result.
4) Replace the received document tray.
• The received document tray must be attached for the fax
machine to operate properly.