Service manual

FO-4400U

FO-CS1

3 – 34

6. Wire treatment

Stamp cable must be passed through six ribs as

shown in fig.1.

Connect the stamp cable to CNSTP (2 pin) of con-

trol PWB

Stamp cable

to Control PWB

(CNSTP) 2pin

Rib

Sensor cable

Scanner

frame unit

Front sensor

cable: Red

CIS cable

Not used

Rib

Document sensor

cable:White

Transfer sensor

cable:Yellow

Rib

Stamp (FO-45VS)

On account of the length of the stamp cable to the

control PWB, it is wired at shortest.

7. Soft switch setting

When you install the verification stamp (FO-45VS),

set the soft SW 27. No. 3 initial setting to "1".

8. Replacing the verification stamp

If you are using the Verification Stamp function, you will need to

replace the ink cartridge in the stamp unit when it runs out of ink

(when the stamped mark on original documents becomes faint).

A new ink cartridge can be obtained from your dealer.

Remove the original document OUT tray.

Fig. 1

Stamp (Ink cartridge) only (20 pieces)

Parts code : UINK-2009SC01

Press down on the protruding tab of the green ink cartridge

and pull the cartridge out with your fingers.

Insert the new ink cartridge into the machine (make sure that

the tab is facing out).

Replace the original document OUT tray.