Specifications

Setting Up the Multifunction Interface
24
Note: There is normally no need to change the parallel port setting in
your computer's setup (BIOS) program. However, if you find that the
Sharp Laser Multifunction fax does not operate well when scanning or
printing, you may need to change the setting. In this case select ECP,
PS2, Bi-directional, or an equivalent parallel port mode.
3
Connect the other end of the cable to
the parallel port on the back of your
computer.
2
Connect one end of the cable to the
port on the Sharp Laser Multifunction
fax. Snap the clips on each side of the
port onto the cable connector to
secure it.
all-fo2950hk.book Page 24 Wednesday, August 9, 2000 11:13 AM