Service manual

1 – 13
UX-4000MU
FO-2950MU/C
2. Message and Signals
Audible signals
Continuous tone
Rapid intermittent
tone
Intermittent tone
(3 beeps)
Indacates the end of
transmission, reception,
or copying.
Indacates incomplete
transmission, reception,
or copying.
Indacates that the hand-
set is off hook.
3 seconds
5 seconds
(1 seconds on, 1
second off)
Continuous
(0.7 seconds on,
0.3 seconds off)
Display messages
CAN'T PRINT DATA
CHECK PC
SIZE ERROR
A fax has been received to memory
because printing is not possible. This
message will alternate with a mes-
sage that indicates the problem. The
fax will print out automatically when
the problem is resolved.
The paper size setting is incorrect.
Change the paper size setting.
This appears if you press the E-MAIL
key and your computer is not turned
on or is not correctly connected to the
fax machine.
COVER OPEN
The print compartment cover is open.
Press down firmly on both sides of the
print compartment cover to close it.
DOCUMENT JAMMED
The original document is jammed.
See the Clearing Paper Jams.
FUNCTION MODE
The FUNCTION key has been
pressed.
GROUP SPACE FULL
This appears if you attempt to pro-
gram a Group Key when all Group
Keys have already been programmed.
HOLD
The HOLD/SEARCH key has been
pressed to put the other party on hold
during a phone conversation.
Press the HOLD/SEARCH again to
take the other party off hold.
LINE ERROR
Transmission or reception was suc-
cessful. Press the STOP key to clear
the message and then try again.
LINE IS IN USE
An extention phone connected to the
fax is being used. Do not lift the fax's
handset or attempt transmission at
this time, as this will interrupt the con-
versation on the extension phone.
MEMORY IS FULL
The memory is full. This may occur
during fax reception if too much data
is received before the pages can be
printed out. If faxes have been
received to memory because printing
is not possible (an additional mes-
sage will indicate the problem),
resolve the problem so that printing
can continue.
MEMORY PRINTING
The fax is preparing to or printing out
a document from memory.
NO DATA
This appears if you attempt to search
for an automatic dialing number when
none have been stored.
NO # STORED
You have tried to dial or clear a Rapid
Key or Speed Dial number that hasn't
been programmed (a full number
hasn't been assigned to it)
OFF HOOK
OUT OF PAPER
ON HOOK DIAL
This appears if you forgot replace the
handset after using it to dial and send
a fax. Replace the handset or press
the STOP key to clear the message.
The SPEAKER key has been pressed
and the fax machine is waiting for you
to dial.
You are out of printing paper (or the
paper release lever is open). Load
paper as explained in Loading Print-
ing Paper.
PAPER JAMMED
The printing paper is jammed. See
the Clearing Paper jams.
SEND READY
A document has been loaded and the
fax machine is waiting for you to
begin faxing or copying.
REPLACE TONER
The toner cartridge must be replaced.
SEARCH DIAL
The HOLD/SEARCH key has been
pressed. Press # or to search for
an automatic dialing number, or press
the STOP key to return to the date
and time display.
TOTAL PAGE(S) 01
Number of pages transmitted,
received, or copied.
TX MEMORY FULL
This message appears if you insert a
document into the document feeder
when 30 transmission jobs are alrea-
dy waiting in memory for transmis-
sion. You can continue setting up the
transmission job after the job current-
ly being sent is completed.
This message may also appear if fax-
es have been received to memory
due to a printing problem. In this
case, resolve the problem so that prin-
ting can take place and free memory.