Service manual

ux-22oocMuIcMc
FO-215ocMuKMc
3. Connections
0
Handset
Connect the handset as shown and place it on the handset rest.
+ The ends of the handset cord are identical, so they will go into
either jack.
Make sure the
handset cord goes
into the unmarked
jack on the side of
the machine!
make ordinary phone
Q Power cord
Plug the power cord into a 120 V, SO Hz, grounded (3-prong)
AC outlet.
Caution!
Do not plug the power cord into any other kind of outlet.
This will damage the machine and is not covered under the
warranty.
@ Telephone line cord
Insert one end of the line cord into the jack on the back of the
machine marked TEL. LINE. Insert the other end into
a standard (RJllC) single-line wall telephone jack.
Note:The Sharp MFP is set for touch-tone dialing. If you are
on a pulse dial (rotary) line, you must set the Sharp MFP for
pulse dialing. Press the following keys on the operation panel:
=-G9
0
until
-Press # display DIAL MODE
-
shows:
TONE PULSE
@or@ I
- TAD CONNECTED
Note:lf your area experiences a high incidence of lightning
or power surges, we recommend that you install surge
protectors for the power and telephone lines.
Surge protectors can be purchased at most telephone
specialty stores.
l-5