Service manual

ux-224mcMu~cMc

m-215ocMu/cMc

[2] Disassembly and assembly procedures

l This chapter mainly describes the disassembly procedures. For the assembly procedures, reverse the disassembly procedures.

l Easy and simple disassembly/assembly procedures of some parts and units are omitted. For disassembly and assembly of such parts and units,

refer to the Parts List.

l The numbers in the illustration, the parts list and the flowchart in a same section are common to each other.

l To assure reliability of the product, the disassembly and the assembly procedures should be performed carefully and deliberately.

l Note on changing cartridges : To prevent the used print cartridge from drying out, be sure to store it in the cartridge holder.

Rear Cabinet, Paper Feed Unlt

Handdet Holder,Printer Back Cabinet

(Al 1x2

PUS

. Cabinet

Disassemblv orocedures (Fia. 1)

STEP REMOVAL

PROCEDURE

1 Rear Cabinet

1. Screw (3x12) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (Al) x 2

2 Document Tray

1. Push inside the Document Tray arms . ...@

3 Paper Feed Unit

1. Screw (3x6) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (Bl) x 1

4 Handset Holder

1. Open the Operation Panel Unit

2. Screw (3x12) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (Cl) x 1

3. Release the Handset Holder lock nails ..@

Printer Back Cabinet

1. Screw (3x10) .__..._.._.___...._............. (01) x 2

Paper Feed Unit

Handset Holder

Fig. 1